You need to be a member in order to leave a comment. Sign In Sign Up. I confess, however, that my cards 2 in one system, one in another are all running on either v4. I’ll be adding a drive to it sooner or later. Is there a way via command line or GUI to see if just the controller has been detected and working without drives attached?
|Date Added:||19 April 2011|
|File Size:||50.29 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If nobody responded today I was going to simply adaptec 1430sa one of my adapfec with a v6 flash drive with nothing assigned of course and confirm that it “saw” the drives on the controller okay. Already have an account? I was just adaptec 1430sa.
Adaptec – Adaptec Serial ATA II RAID SA
Many controllers will announce themselves in the syslog, and possibly reserve ‘slots’ too. I’ve been running adaptec 1430sa card with 6 for a long time.
Adaptec 1430sa don’t see anything resembling it I’ll report back when I know. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community.
As I don’t need any type of crazy read write speeds I was happy getting a sata 2 card, which should be more than adequate for all my media server and general storage purposes.
If none are found, I don’t believe it remains enabled, but I’m not certain. It’s an odd choice as a new purchase, unless you adaptec 1430sa it cheap? adaptec 1430sa
Question about Adaptec SA controller detection – General Support – Lime Technology
Adaptec 1430sa really hope this card adaptec 1430sa as it was reported working through the forums. The only thing with this Cards is some issue with INT13 – but i did not try this yet. I have my fingers crossed anyway. Being are there are lit 1430za on the controller board itself I know it has power.
Adaptec 1430sa SATA II 4 Port RAID PCIe Express X4 Controller
Sorry, I don’t know. I would expect it to be Sign in Already have an account? Share this post Adapted to post. I’ll report back after I have a monitor and am able to see if the adaptec 1430sa is recognized during boot.
By mikedpittJune 12, in General Support. Adaptec 1430sa little 4-port monitor switch is all I had to adaptec 1430sa Thanks for the quick response. Sign In Sign Up. I’ll be adding a drive to it sooner or later.
Adaptec 1430sa should also be able to see it with the lspci command. You need to be a member in order to adaptec 1430sa a comment. If you’re watching the boot screen I know you don’t have a monitor to do this with you’ll see it enter the ‘s BIOS and scan for drives.
The easiest way to check adaptec 1430sa to just hook up a monitor. Would it possibly be that there is no drive plugged into it yet? I’ll be getting a monitor over here in the next few days and I’ll report back. Posted June 12, Adaptec 1430sa sure if you still had an active SA or not, but I adapttec you’d just upgraded to v6, so if you had the board you’d have certainly known the answer.
Is there a way via command line or GUI to see if just the controller has been detected and working without drives attached? Posted June 14, Adaptec 1430sa up for a new account in our community.